PSM(D) 4000-48PSM(D) series battery charger/inverter is the heart of your energy system and so the key element for a smart, efficient and smooth energy management.An PSM(D) consists of the DC-AC Inverter, AC-DC Battery charger, AC-AC Transfer system, and UPS. 2 auxiliary contacts allow automatic control of a genset, the discoennection of non-priority loads or other programmable functions. These functions can be controlled in a totally automatic way for an optimal management of available energy in hybrid systems, in combination with VictorTeam MPPT solar charge controllers.
1.Compatible with most battery technologies· like: AGM, GEL, Flooded LA NiCad, NiFE, Aquion, Redox, Lithium.
2.Transfer Switch(UPS、Back up power)·0 ms transfer time when switching from Inverter to AC input source ·＜0.15 ms transfer time when switching from Inverter to AC input source
3.Surge Capacity (inductive load)·The inverter has a surge capability of 3X its continuous power rating. ·The inverter load can exceed the continuous output power for up to 30 minutes, allowing a power boost without triggering and overload failures. ·There is no need to choose more powerful inverters because of the excess load of a little time, which will greatly reduce the cost.
4.Ac input·Can access 2 kinds of AC power supply, and the two kinds of AC power supply for programming. ·Compatible with any kind of AC source. ·6 stages battery charging： ·Bulk-Absorption-Floating-Equalization-reduced-floating-periodic absorption ·Solar priority or battery priority can be set.
5.Modular design·Up to 2 sets in series to increase output power. ·Up to 3 parallel to increase single-phase output power. ·3 sets in parallel can form the three-phase power supply, up to 9 sets in parallel to form the three-phase power supply。
6.Remote monitoring function·Local monitoring and data acquisition through RCC. ·Monitoring system through mobile APP SmartEss. ·Monitor the system through the Web side.
7.Electronic protection functions·Deep discharge protection. ·Battery overvoltage shutdown . ·Short circuit protection. ·Overtemperature and overload protection. ·Reverse polarity protection by internal fuse(except XTH3000). ·Acoustic alarm at deep discharge or overheating.
Model PSM(D) 1500-12 PSM(D) 2000-12 PSM(D) 2400-24 PSM(D) 3500-24 PSM(D) 2600-48 PSM(D) 4000-48 Characterisation of the operating performance Nominal battery voltage 12V 12V 24V 24V 48V 48V Input voltage range 9.5-17VDC 9.5-17VDC 19-34VDC 19-34VDC 38-68VDC 38-68VDC Continuous power 1500VA 2000VA 2000VA 3000VA 2000VA 3500VA Power 30 min. 1500VA 2000VA 2400VA 3500VA 2600VA 4000VA Power 5 sec. 3400VA 4800VA 6000VA 900oVA 6500VA 10500VA Max. efficiency 93% 93% 94% 94% 96% 96% Own consumption stand by 1.4W 1.4W 1.6W 1.6W 2.0W 2.1W Own consumption ON 8.0W 10W 9W 12W 10w 14W Acoustic level without ventilation 40 dB Acoustic level with ventilation 45 dB Maximum load Up to short-circuit Maximum asymmetric load Up to Pcont. Load detection (stand-by) 2 to 25 W Cos φ 0.1-1 Output voltage Pure sine wave 230Vac (±2%)/120Vac(1) Output frequency 45Hz-60Hz(1)±0.05%(crystal controlled) Harmonic distortion <2% Overload and short-circuit protection Automatic disconnection with 3 time restart attempt Overheat protection Warning before shut-off-with automatic restart Battery charger Charge Characteristic 6 steps: Bulk-Absorption-Floating-Equalization-reduced floating-periodic absorption Number of steps, thresholds,end current and times completely adjustable with the RCC-02/-03 Temperature compensation With BTS-01 or BSP 500/1200 Power Factor Correction(PFC) according EN 61000-3-2 Maximum charging current 70A 100A 55A 90A 30A 50A Input voltage range 150 to 265Vac/50 to 140Vac(1) Input frequency 45 to 65Hz Input current max. (transfer relay)/Output current max. 50Aac/56Aac Transfer time <15ms Multifunction contacts 2 independent contacts(potential free 3 points,16Aac/5Adc) Dimension h×w× [mm] 188.5×326×510 Protection index IP20 Operating temperature range -20 to 55℃ Relative humidity in operation 95% without condensation Ventilation Forced from 55 Warranty 2 years Weight 16.3Kg 19Kg 21.5Kg 23.5Kg 16.7Kg 23.5Kg
The technology of our products comes from Europe and is manufactured in China. Choosing us is equivalent to choosing a good and inexpensive product.Our Battery Charger/Inverter start offer in 2019 , till now still hot sale. We improved the quality constantly in the first 2 years even the packing box according to our customers required. And we are assured our quality is perfect. we tested the goods before shipping.
The Bolanmu Battery Charger/Inverter series is a true energy manager, unique and compact, that has 5 main functions. It can be an off-grid inverter, battery charger, current injector, transfer system and provide support to an AC source.